< back
Projects > iTopography v4.2 - Advanced Area Calculator
ScreenShots for Version 1.0
First release
The table shows some information about the acquired points. In total, six points were acquired, among which the first point was acquired with the GPS device. and the other points were manually given; We gave the length of each side of the polygon and the vertex angle.

So, the side of the polygon that would connect the 2nd with the 3rd point is 1.10m and the angle of the second vertex is 120o.

iTopography calculated the coordinates (x,y) of the six points and it drew the surface. At the top of the screen we read the area of the surface and the perimeter.
These are the settings. Currently, you can change the units, and control the accuracy of the GPS device. We provide two methods to control the accuracy: "Accuracy", iTopography will keep getting data from the GPS device until the accuracy for the location of the point is less than the value specified here. Because, this may take some time, iTopography will make only certain number of "Attempts" to obtain the given accuracy.

Therefore, if after 5 attempts, iTopography was not able to get the location of the point with an accuracy less than 108m, a warning message will appear.

© 2010-2019 i-SmartSolutions | All rights reserved